Filter
Top Products
18
CT10016N PARTS LIST
Item
No.
Part No. Qty Description
1 00118 1 Retaining Ring
2 00144 14 HSHCS
3 07626 2 O-Ring
4 09330 1 O-Ring
5 00294 1 O-Ring
6 00360 1 O-Ring
7 00936 2 Adapter
8 01259 1 O-Ring
9 01521 2 HSHCS
10 01534 1 Roll Pin
11 01608 4 Steel Ball
12 01809 1 Valve Spool
13 01812 1 Valve Spool Screw
14 03014 1 Washer †
15 67281 1 Capscrew *
15A 03870 1 Capscrew **
16 06324 1 Die Piston Assy.
17 06326 1 Washer †
18 06332 1 O-Ring
19 66588 1 C-Frame *
19A 06333 1 Retainer Die Yoke **
20 67279 1 Set Screw Kit *
20A 07438 1 Key & Capscrew Kit **
21 16556 1 Spring
22 18050 1 Back-Up Ring
23 21424 1 Relief Valve
24 22147 2 Capscrew
25 38622 1 Valve Sleeve
26 39925 1 Compression Spring
27 39939 1 Valve Handle
28 51182 1 Trigger Guard
29 51183 1 Trigger
30 52534 2 Setscrew
31 58439 1 Adapter
32 58440 1 Retaining Ring
33 58441 1 Sleeve
34 58442 1 Oil Tube
35 58480 1 Piston
Item
No.
Part No. Qty Description
36 58485 1 O-Ring
37 58493 1 Cylinder
38 67276 1 Cylinder Head *
38A 58494 1 Cylinder Head **
39 58499 1 Sticker
40 58583 1 T-Seal
41 58594 1 Retaining Ring
42 67277 1 Set Screw *
43 67259 1 Check Valve Assy *
44 67280 1 Key
58551 1 SEAL KIT
NOTE 1: Items 38 and 38A differ in several ways and are
not interchangeable. The following information explains the
differences.
Item 38A contains 2-3/16-16UN threads and cannot be
used with items 19 that contain M60 metric threads. Like-
wise, items 19 and 38 that contain M60 metric threads can-
not be used with items 19A and 38A that contain 2-3/16-
16UN threads.
Item 38 and 38A can be identied by measuring the length
of the threads (see gure below). The length of threads for
item 38 is 1.100 inches. For item 38A the length is 1.100
inches. Due to both of these cylinder heads having the
same thread length, you will need to measure the thread
diameter to know wheather you have a M60 metric thread
or a 2-3/16 16UN thread.
CT10016N
Cyl Head P/N Thread Length Thread Diameter
67276 (item 38) 1.100 M60x1.5
58494 (item-38A) 1.100 2-3/16
To determine which model you have, measure the thread
length and diameter on the cylinder head.