Filter
Top Products
• 6 •
1. Ensure the battery clips are securely clipped on the storage holders.
2. Open the protective cover of the DC power outlet on the back of the Instant Power™.
3. Plug the 12V DC device into the DC power outlet, and turn the 12V DC device on (if
required).
4. If the 12V DC device draws more than 15A or has a short circuit, the internal circuit
breaker of the Instant Power™ will trip and disconnect the power to the device. If this
occurs, disconnect the 12V DC device in question and press the reset button located
on the back of the Instant Power™ to reset the circuit breaker.
The DC power outlet is wired directly to the internal battery. Extended
operation of a 12V DC device may result in excessive battery drain.
Recharge immediately after unplugging the 12V DC device.
8.3 Using the Built-In Light
1. Position the Instant Power™ on a at, stable surface near the intended work area.
2. Ensure the battery clips are securely clipped on the storage holders.
3. Press the Light Switch to the ON position.
4. The Instant Power™ light will turn on and illuminate your work area.
5. Press the Light Switch to the OFF position to turn off the light.
6. Charge the Instant Power™ as soon as possible after using the built-in light.
NOTE: With a fully charged internal battery, the built-in light should provide 55 to 65
hours of continuous, useful light.
8.4 Using the Air Compressor
RISK OF EXPLOSION.
Read the instructions of the product being inated before using the compressor.
Avoid overination; do not exceed the manufacturer’s recommended pressures.
Do not leave the air compressor unattended during use.
1. Ensure the battery clips are securely on the storage holders.
2. Remove the air compressor hose from the storage compartment in the back of the
Instant Power™. Install adapters as necessary.
3. Attach the air compressor hose to the product or accessory to be inated by ipping
down the lever.
4. Place the Compressor Switch in the ON position and inate the product.
5. When the product is inated to the proper air pressure (using the air compressor
gauge) place the Compressor Switch in the OFF position and remove the hose.
6. Do not run for more than 10 minutes maximum at a time. Allow the Instant Power™
to cool down for 10 minutes before using again.
NOTE: To prevent overheating, the compressor has built-in thermal protection that
will turn the compressor off before it overheats. If the compressor shuts off, wait a few
minutes and it will automatically restart when the compressor cools.
NOTE: The air compressor is rated for 150 PSI.
9. MAINTENANCE INSTRUCTIONS
9.1 After use and before performing maintenance, unplug and disconnect the Instant
Power™.
9.2 Use a dry cloth to wipe all battery corrosion and other dirt or oil from the battery clips,
cords, and the Instant Power™ case.
9.3 Ensure that all of the Instant Power™ components are in place and in good working
condition, for example, the plastic boots on the battery clips.
9.4 Servicing does not require opening the unit, as there are no user-serviceable parts.
9.5 All other servicing should be performed by qualied service personnel.
10. MOVING AND STORAGE INSTRUCTIONS
10.1 Store the Instant Power™ in an upright position.
10.2 Store inside, in a cool, dry place.