Filter
Top Products
A rear blow out, particularly on a curve, acts much
like a skid and may require the same correction
you would use in a skid. In any rear blow out,
remove your foot from the accelerator pedal.
Get the vehicle under control by steering the way
you want the vehicle to go. It may be very
bumpy and noisy, but you can still steer. Gently
brake to a stop, well off the road if possible.
If a tire goes flat, avoid further tire and wheel
damage by driving slowly to a level place
and stopping. Then do this:
1. Turn on the hazard warning flashers.
2. Park your vehicle. Set the parking brake
firmly and put the shift lever in PARK (P).
See Shifting Into Park (P) on page 122
for additional information.
3. Turn off the engine.
4. Inspect the flat tire.
If the tire has been separated from the wheel or
has damaged sidewalls or large tears that
allow rapid air loss, call a tire repair facility.
See Roadside Assistance Program on page 413.
If the flat tire is due to a slow leak caused by a
nail or other similar road hazard, the tire inflator kit
may be used to repair the damaged tire
temporarily. The kit uses a liquid tire sealant to
seal small punctures in the tread area of the tire.
After repairing a tire with the tire inflator kit,
take your vehicle to an authorized retailer to have
the tire inspected and repaired as soon as
possible. The tire sealant is a temporary repair
only. See Tire Inflator Kit on page 358.
Tire Inflator Kit
Your vehicle has a tire inflator kit. There is no jack
or spare tire. The kit uses a liquid tire sealant
and air at the same time to seal small punctures
in the tread area of the tire. Be sure to read
and follow all of the tire inflator kit instructions.
358