Filter
Top Products
8. Make sure there is a proper connection
between the tire valve stem and the sealant
filling hose by looking at the air pressure gage.
If there is not a pressure reading while the
compressor is running, the connection between
the inflator kit and the tire is bad.
Check the attachment between the sealant
filling hose and the tire valve stem.
9. Inflate the tire up to the recommended
inflation pressure, found on the Tire and
Loading Information label located on
the vehicle’s center pillar (B-pillar) below the
vehicle’s door latch, using the air pressure
gage on the top of the unit.
The pressure gage reading is slightly high
while the compressor is on. Turn the
compressor off to get an accurate pressure
reading.
Notice: If the recommended pressure cannot
be reached after 15 minutes, the vehicle
should not be driven farther. Damage to the
tire is severe and the sealant will not be
effective. Remove the air compressor plug
from the accessory power outlet and unscrew
the inflating hose from the tire valve. See
Roadside Assistance Program on page 377.
10. Push the inflator kit switch to the O (off)
position once the correct tire pressure is
obtained.
11. Turn off the engine.
325