Filter
Top Products
RES+ (Resume): Press RES+ to resume a set
speed and to accelerate the speed.
SET− (Set): Press SET– to set a speed and to
decrease the speed.
To set a speed do the following:
1. Press
I to turn cruise control on. The
indicator light on the button comes on.
2. Get up to the desired speed.
3. Press the SET− and release it. The cruise
symbol displays in the instrument panel
cluster to show the system is engaged.
4. Take your foot off the accelerator pedal.
When the brakes are applied, the cruise control
shuts off.
If the vehicle is in cruise control and the Traction
Control System (TCS) begins to limit wheel
spin, the cruise control automatically disengages.
See Traction Control System (TCS) on page 217.
When road conditions allow, the cruise control
can be used again.
Resuming a Set Speed
Suppose you set the cruise control at a desired
speed and then apply the brakes. This disengages
the cruise control. The cruise symbol in the
instrument panel cluster also goes out indicating
cruise is no longer engaged. To return to the
previously set speed, you do not need to
go through the set process again. Once the
vehicle is at a speed of about 25 mph (40 km/h) or
more, you can briefly press the RES+.
This takes the vehicle back up to the previously
chosen speed and stays there.
Increasing Speed While Using Cruise
Control
There are two ways to go to a higher speed.
• If the cruise control system is already
engaged, press the RES+. Hold it there until
you reach the desired speed, and then release
the button.
• To increase the vehicle’s speed in very small
amounts, briefly press the RES+ and then
release it. Each time this is done, the vehicle
goes about 1 mph (1.6 km/h) faster.
146