Filter
Top Products
- 5 -
Step Parts to remove Renarks and procedures Parts Fasteners
10
Throttle body,
Insulator
(1) Disconnect the fuel pump pulse line from the throttle body.
(2) Leaving the wire harness plugged into the throttle body, disconnect
the EFI wire harness from the engine.
(3) Remove the harness ground (black) from the top of the crankcase.
(4) Disconnect the engine temperature sensor (yellow) from the back
of the throttle bracket.
(5) Disconnect the low oil sensor lead (orange) and the power
generation lead (red) from the harness.
(6) Once the wire harness is completely free from the engine, remove
the throttle body with wire harness from the cylinder head.
Remove the insulator.
M5 tapping screw
+ screwdriver
10mm box spanner
M6 × 12mm : 2 pcs
STEP 10
INSULATOR
GASKET
GASKET
THROTTLE BODY
FUEL PUMP
PULSE LINE
M6 12 BOLT
M5 TAPPING
SCREW
WIRE HARNESS