Filter
Top Products
9)
VALVE CLEARANCE ADJUSTMENT
NOTE
:
Temporally fit the flywheel in position for easy operation.
(1)
Rotate crankshaft clockwise to the TDC (top dead center) of compression stroke by matching the
(2)
Loosen the nut on rocker
am
and turn the pivot to adjust the clearance between rocker arm and valve
mark
"T"
of flywheel with the mark
"1"
of
#1
cylinder head.
stem end,
and
then tighten the nut by the specified torque.
Valve Clearance
:
0.085
-
0.115
mm
(Cold condition)
(0.0033
-
0.0045
in.)
Tightening Torque
:
7.8
-
9.8
N-rn
(80
-
100
kg-cm)
(5.8
-
7.2
ft-lb.)
ICKNT GAUG;
(3)
Adjust valve clearance of
#2
cylinder side in
the same manner.
(4)
Rotate crankshaft several times and be sure
to
check valve clearance again. Adjust valve
clearance
if
necessary.
Fig.
5-35
'
FLYWHEEL
Fig.
5-36
-
35-