Filter
Top Products
10
Locking Lever
MOUNTING YOUR DEVICE
Your SPOTTER GPS Navigator can be easily secured to either the windshield or the dashboard for
optimal viewing while driving. The mounting system consists of the following pieces:
Adjustable arm with suction cup
SPOTTER cradle
Dash disk with adhesive backing
ATTACHING THE MOUNT
1. Select a location for the mount on the windshield or dashboard that does not
view or interfere with the operation of the vehicle.
2. Clean and dry this area to remove any grease and dirt.
If mounting the SPOTTER on the dashboard, remove the protective backing
from the dash disc, exposing the adhesive. Adhere the disc to the dashboard
in the desired location.
The adhesive is permanent.
3. Place the suction cup on the desired location on the windshield or
dash disc; push the locking lever towards the base of the mount.
The mount should stick to the surface.
If your mount does not stick, make sure the area is clean and
dry, then try again.
4. Align the tabs on the adjustable arm with the slots on the
SPOTTER cradle. Slide together until you feel a firm click.
5. Adjust the holder to the best viewing angle by:
a. Loosening the adjustor dials
b. Moving the corresponding part to the desired position
c. Tightening the adjustor dials.