Filter
Top Products
8
NOTE regarding the E300 rear wheel: Inflating the rear tire of
the E300 requires the use of a special valve extender/adapter, supplied
with the scooter at time of purchase (Figure 7). To inflate the rear tire
align the access hole in the drive sprocket with the tire valve. Thread
the adapter completely onto the valve. Attached pump and inflate to 35
psi.
The valve adapter must be removed immediately after inflating.
Failure to remove the adapter will cause the inner tube and or
adapter to be severed by the rear drive sprocket. Place the adapter
in a safe place for later use.
Figure 7.
Note regarding using an air hose at a gas station. The
pressurized air supplies found at gasoline stations are designed to
inflate high volume automobile tires. These systems are capable of
instantaneously over-inflating the tires. If you decide to use such a
supply to inflate your ties, make sure the pressure gauge is working
prior to inflating the tires. Use very short bursts to inflate to the correct
psi. If you inadvertently over-inflate the tire, release the excess pressure
immediately.
2F. The brake. Your scooter is fitted with a hand-operated brake (Figure
8). To use the brake, squeeze the lever to increase the pressure on the
brake until so you come to a smooth and controlled stop. The brake
lever is fitted with a cable adjuster to compensate for cable stretch
and/or to fine tune the lever movement to brake engagement. To adjust
the play, thread the adjuster in or out (arrows, Figure 8) 1/4 to 1/2 turn
until the desired brake adjustment is attained.