Filter
Top Products
6
2C. Unfolding the handlebar. Pivot the handlebar assembly upright.
Swing the locking knob to the 12 o’clock position and tighten as shown
in Figure 4. Tighten by hand as tight as possible.
Figure 4. Tighten the locking knob.
WARNING: Keep your fingers clear of the pivoting mechanism
when folding or unfolding the scooter. Make sure others are standing
clear.
NOTE: The cable and wire assembly from the handlebar must
not be wrapped around the steering tube or over the handlebar. The
cables and wires should be routed as shown on the front cover of the
manual. Sharp bends or twisting of the brake cable can cause the brake
to be mushy or drag.
2D. Handlebar height. To adjust the height of the handlebars, unlock
the steering tube by pulling outward on the quick-release lever (Figure
5). Slide the T-tube to the desired position and secure by pushing the
quick release lever (Figures 5a and 5b). The tension of the quick-
release clamping mechanism can be adjusted by tightening or
loosening the Allen bolt (Figure 5c) . Be careful not to over-tighten. You
should always be able to open and close the quick-release lever by
hand and the T-tube should telescope freely with the quick-release
open.