Filter
Top Products
2
1
3
4
14-17 N-m
77
MAINTENANCE AND LUBRICATION
Steering / Suspension
Steering Assembly
Check the steering assembly of
the vehicle periodically for loose
nuts and bolts. If loose nuts and
bolts are found, see your P olaris
dealer for service before
operating the vehicle.
Handlebar Adjustment
1. Remove the two hex
screws (1) from the
instrument panel (2).
Remove the instrument
panel.
2. Loosen (do not
remove) all four
handlebar bolts.
3. Adjust the handlebar
to the desired height.
NOTE: Make sure the
handlebars do
not contact the
gas tank or any part of
the machine when turned
fully to the left or right.
4. Torque the two front bolts (3), then torque the two rear bolts (4).
=14-17 N-m
NOTE: A gap of up to 3 mm should remain at the rear bolts.
WARNING
Improper adjustment of the handlebars or incorrect torquing of
the adjuster block tightening bolts can cause limited steering or
loosening of the handlebars, resulting in loss of control. Follow
the adjustment procedures exactly, or see your Polaris dealer for
service.