Filter
Top Products
37
OPERATION
Starting the Engine
10. Activate the starter for a maximum of five seconds, releasing the
button when the engine starts.
NOTICE: Operating the vehicle immediately after starting could cause engine
damage. Allow the engine to warm up for several minutes before
operating the vehicle.
11. If the engine does not start, release the start button, wait five sec-
onds, then attempt to start again. Repeat this procedure until the
engine starts.
12. If the engine slows or stops, move the choke lever half way to the
right to allow proper engine warm-up. Vary the engine RPM
slightly with the throttle to aid in warm-up.
13. When the engine idles smoothly, move the choke lever completely
to the right.
Cold Weather Operation
If the ATV is used year-round, check the oil level frequently. A rising oil
level could indicate the accumulation of contaminates such as water or
excess fuel in the bottom of the crankcase. Water in the bottom of the
crankcase can lead to engine damage and must be drained.
Tip: Water accumulation increases as outside temperature decreases.
If the oil level rises to the top of the sight glass, change the oil immedi-
ately. Always operate the engine long enough to reach operating temper-
ature, which reduces condensation.