Filter
Top Products
106
MAINTENANCE AND LUBRICATIO N
Lights
WARNING
Operating the vehicle on streets or roads, especially in darkness,
could result in a n a ccident and serious injury or death.
Your Sportsman 6x6 is not equipped with highway-approved
lights. It’ s designed for and must be used for off-road use only.
Use caution and drive at reduced speeds in conditions of reduced
visibility such as fog, rain and darkness.
High Beam Headligh t Adju stment
The headlight beam can be adjusted to any position desired by turning
the adjusting knob located on the bottom right side of the headlight
pod.
1. Place the vehicle on a level surface with the headlight
approximately 25 ft. (7.6 m.) from a wall.
2. Measure the distance from the floor to the center of the headlight
and make a mark on the wall at the same height.
3. Start the engine and turn the headlight switch to high beam.
4. Observe the headlight aim on the wall. The most intense part of
the headlight beam should be aimed two inches (5.1 cm) below the
mark placed on the wall.
NOTE: Include rider weight on the seat when measuring.
5. Adjust the beam to the desired position by turning the adjustment
knob either clockwise or counterclockwise.