Filter
Top Products
33
FEATURES
Instrumentation
MFD Settings
With the engine running, use the
MFD Control Switch to set the MFD
display to your preference. The
rocker switch (✪) has a MODE but-
ton (top) and a SET button (bottom).
Standard vs. Metric
The MFD will display either stan-
dard or metric units of measurement.
While viewing a screen that displays
measurements (MPH, KPH or tem-
peratures), press and hold the MODE switch until the unit of measure-
ment changes (about 10 seconds).
Speedometer/Tachometer
The speedometer and tachometer can be viewed in either the analog or
the digital display. If the analog display is set to show speedometer read-
ings, the digital screen will automatically display the tachometer (option
1). If the analog is set to show the tachometer, the digital screen will
show the speedometer (option 2).
To change preferences, press and hold the MODE button for three sec-
onds. When the button is released, the new setting becomes active and
screen colors change. See table below.
Option
Analog
Display
Digital
Display
Analog
Screen
Digital
Screen
1 Speed RPM Blue “mph” Blue
Backlight
2 RPM Speed Red
“X100rpm”
Red
Backlight
✪