Filter
Top Products
80
MAINTENANCE AND LUBRICATION
Lubrication Recommendations
Oil and Filter Change
1. Place the v ehicle on a level surface.
2. Run the engine for two to three minutes until warm. Stop the
engine.
3. Clean the area around the drain plug.
4. Place a drain pan beneath engine crankcase and remove the drain
plug.
5. Allow the oil to drain completely.
6. Replace the sealing washer on the drain plug. NOTE: The sealing
surfaces on drai n plug and crankcase should be clean and free of
burrs, nicks or scratches.
7. Reinstall the drain plug and torque to 14 ft. lbs. (19 Nm).
8. Place shop towels beneath the oil filter. Using an oil filter wrench,
turn the filter counterclockwise to remove.
9. Using a clean dry cloth, clean the filter sealing surface on the
crankcase.
10. Lubricate the o-ring on the new filter with a film of fresh engine
oil. Check to make sure the o-ring is in good condition.
11. Install the new filter and turn by hand until the filter gasket
contacts the seal ing su rface, then turn and add itional 1/2 turn.
12. Remove the dipstick and fill the sump with 2 quarts (1.9 l) of
Polaris Premium 4 synthetic oil.
13. Place the gear selector in neutral and set the parking brake.
14. Start the engine and let it idle for one to two minutes. Stop the
engine and insp ect for leaks.
15. Re-check the oil level on the dipstick and add oil as necessary to
bring the level to the upper mark on the dipstick.
16. Dispose of used filter and oil properly.
CAUTION
Hot oil can caus e serious burns to skin. Do not allow hot oil to
come into c ontact with skin.