Filter
Top Products
63
ADULT SECTION
Maintenance
Controls and Lin kag e
All bushings, spindle shafts, and tie rod ends should be coated with a
light coat of oil or grease. Throttle and brake controls and cables
should be lubricated with Polaris Premium All Season Grease. Force a
small amount of lubricant down the cable.
Bearings
To prevent corrosion which will destroy t he bearings, always grease
drive shaft clutch side bearings with a high quality bearing grease.
Electrical Connections
Separate electrical connector blocks and clean corrosive build up from
connectors. Lubricate or pack connector blocks with Nyogelt grease
and re-connect. Replace worn or frayed electrical wire and connectors.
Be sure wiring harness is properly secured away from sharp edges,
steering linkage, moving parts, and hot exhaust.
Front Suspension
To minimize fatigue on the front shocks and springs during extended
storage, it is recommended that the front end of the machine be safely
blocked off the ground to remove tension from the shocks and springs.