Filter
Top Products
24 Pelco Manual C554M-A (5/98)
7.0 SPECIFICATIONS
MECHANICAL
Latching
Fiberglass Box: Two latches (accommodates padlocks - not supplied)
Anodized
Metal Box: No latches. Two Phillips head screws open cover of box.
Painted
Metal Box: Two latches (accommodates padlocks - not supplied)
ELECTRICAL
Input Voltage
Fiberglass Box: 120 VAC, 60 Hz (jumper selectable for 230 VAC, 50 Hz)
Anodized
Metal Box: 120 VAC, 60 Hz (jumper selectable for 230 VAC, 50 Hz)
Painted
Metal Box: 230 VAC, 50 Hz (CE version models)
Fuse Protection: See Figure 7, AC Input and Fuse Values
Power
Consumption
Receiver: 5 vA (120 VAC or 24 VAC)
Pan/Tilt Supply: 140 vA maximum (120 VAC)
50 vA maximum (24 VAC)
Lens Supply: 0-4 vA maximum
Camera Supply: 15 vA (typical)
Control Method: 15-pulse train (pulse width modulated) superimposed on the
video signal during the vertical blanking interval by the control
transmitter. Pulse train occupies one TV line period.
Pulse Amplitude: Approximately 1 Vp-p added to video signal, 333 kHz nominal
Connectors: Two BNC connectors for video input and output
One 37-pin AMP CPC for control output (mate supplied)
One adjustable PG-13 liquid tight gland connector for power
Input Video Level: 1 Vp-p nominal; 2 Vp-p maximum at less than 75 percent APL;
1.5 Vp-p maximum at 90 percent APL
System Bandwidth: Less than 2 dB down at 10 MHz (exclusive of cable)
Power Cord: 3-wire grounded, #18 AWG
GENERAL
Construction
and Finish: Dark gray fiberglass box (Most outdoor models)
Anodized Aluminum box (Most indoor models)
Gray polyester powder coat Aluminum box (230 VAC CE
version models only)
Operating
Temperature: -4° to 140°F (-20° to 60°C)