Filter
Top Products
Pelco Manual C554M-A (5/98) 13
Figure 2. Receiver Control Output/Input Pin Assignments
P1
3 BRN P/T COM 1
5 ORG LEFT 3
8 4
7 GRN DOWN 5
6 BLU UP 6
4 VIO RIGHT 7
9 GRAY GROUND 8
12 BLACK IRIS 10 1
11 W/BRN FOCUS 11 3 LENS
10 W/RED ZOOM 12 2 INPUT
14 W/ORG LENS COM 13 4
13 RED MAN IRIS 2 5
1 WHITE CAM AC HIGH 9 CAMERA
2 W/YEL CAM AC LOW 14 INPUT POWER
P2
RECEIVER CONTROL
OUTPUT PIN
ASSIGNMENTS
(GOING TO THE
37-PIN AMP
CONNECTOR)
RECEIVER CONTROL
INPUT PIN
ASSIGNMENTS
(P1 & P2 ARE
LOCATED ON
THE COAXITRON
®
RECEIVER CARD)
NOTE: CONSULT
FACTORY BEFORE
ATTEMPTING TO USE
AUX FUNCTIONS.
EXTERNAL REQUIRE-
MENTS ARE NEEDED.
10 BRN/W +21V 28
9 RED/W CAM ON 29
8 ORG/W AUX 1 30 AUXILIARY
7 YEL/W CAM OFF 31 WIRING
6 GRN/W AUX 4 32 PROVIDED IN
5 BLU/W AUX 3 33 OUTDOOR
4 VIO/W AUX 2 34 MODELS ONLY
3 GRY/W LOGIC RESET 35
2 W/GRY GROUND 36
1 BLK/W +10V 37
* FOR REV K BOARDS, THE SW1 SWITCH POSITION IS THE REVERSE OF THAT SHOWN ABOVE; THAT IS,
“SHORT” IS “LONG” AND “LONG” IS “SHORT”. SEE FIGURE 4 FOR JUMPER SETTINGS.
COAXITRON
®
RECEIVER
P 1
P 2
SW1 ** SHOWN IN THE
“SHORT” POSITION
BNC CONNECTORS
37-PIN
CONNECTOR
POWER INPUT
PC BOARD