Filter
Top Products
Pelco Manual C554M-A (5/98) 11
3.3 CONNECTOR ASSEMBLY
Assemble the connector parts according to the instructions below. Detail B, in Fig-
ure 1, reflects the pin arrangement specific to the CX9000 Series receiver/drivers.
Refer to Figures 1 and 2 during assembly. For best results, use an AMP style crimper
when making the wire to pin connection.
The instructions that follow apply to all AMP style connectors regardless of pin size
or pin number.
1. Slide the connector clamp assembly over the conductor cable. If the diameter
of the conductor cable is such that the rubber boot will slide over it easily then
slide the rubber boot onto the conductor cable at this time. If not, discard the
rubber boot.
2. Prepare the wires from the conductor cable as follows:
a. Strip at least 1-inch (2.54 cm) from the cable jacket to expose the wires.
You may need to strip more from the cable jacket if you have more wires.
b. Strip 1/8-inch (0.318 cm) from each wire.
c. Using an AMP style crimper, crimp the wires and their insulation to the
connector pins. Refer to Detail A in Figure 1.
3. Slide the connector pins into the appropriate holes in the connector body until
they snap into place. Refer to Figures 1 and 2 for correct pin arrangement,
depending on model and options.
If your camera uses 12 VDC camera power, see Section 3.3.1, RECEIVER
CONTROL OUTPUT FOR 12 VDC CAMERA OPTION.
If your receiver/driver has preset positioning, wire the presets. See Section 3.4,
COAXITRON
®
RECEIVER PRESETS.
If you will use auxiliary functions to drive small relays, lamps, or other external
devices, see Section 3.5, AUXILIARY FUNCTIONS.
4. Push the connector clamp assembly (with boot, if used) toward the connector
body. Screw the clamp assembly onto the connector body, being careful not to
disturb the wires.
5. To complete the assembly, attach the appropriate clamp with the screws pro-
vided and tighten.
6. When you are finished wiring the connector, connect the 37-pin assembly into
the CX9000.
Proceed to Section 3.6, POWER
WARNING:
There is no
on/off switch. The CX9000
is “hot” when the fuse is
installed and the input wir-
ing is connected.
WARNING:
Power for
enclosure models utilizing
heater/blowers cannot be
tapped off the secondary
of the Coaxitron
®
receiver
transformer or off of cam-
era AC power (see Figure
2, Pins 9 and 14). Instead,
for example, enclosure
power for these purposes
could be run off the pri-
mary of the Coaxitron
®
transformer and routed to
the enclosure via unused
Pins 15 and 16 of the 37-
Pin connector.