Filter
Top Products
To use the bed extender in the outward position
perform the following:
1. Open the tailgate.
2. Rotate the bed extender
᭺
2
away from the
cab of the truck until the extender sits on the
tailgate.
3. Lock the buckles
᭺
3
into the tailgate latch.
The bed extender can be adjusted in the outward
position by moving the extender along the rail.
NOTE:
Use care when rotating extender, buckles
may come in contact with the truck bed
railing.
Removing and installing the bed
extender
To remove or install the bed extender perform the
following:
1. Open the tailgate.
2. Rotate the bed extender into a vertical posi-
tion and lift straight up (to remove) or lower
straight down (to install).
To store the bed extender in the front of the truck
when not in use perform the following:
1. Position the sliding brackets past the center
of the wheel well.
2. Re-installthe extender into the brackets (see
above).
3. Rotate the extender to the inward position.
4. Push the brackets forward until the extender
comes in contact with the front wall of the
truck box.
TIE DOWN HOOKS (if so equipped)
For your convenience, tie down hooks are placed
at each corner of the truck box. These may be
used to help secure cargo loaded into the truck
box.
● The weight of the cargo load must be evenly
distributed over both the front and the rear
axles.
● All cargo should be securely fastened with
ropes or straps to prevent it from shifting or
sliding within the vehicle.
LPD0479 LTI0102
3-18 Pre-driving checks and adjustments