Nissan 2010 Automobile User Manual


 
KEYFOB (if so equipped)
Replace the battery in the keyfob as follows:
1
Open the lid using a coin
A
.
2
Remove the battery
B
.
3
Install a new battery
C
with the “+” facing
down.
Hold the battery by the edges. Holding the
battery across the contact points will seri-
ously deplete the storage capacity.
Do not touch the internal circuit and electric
terminals as it could cause a malfunction.
When changing the battery, do not let dust
or oil get on the keyfob.
There is danger of explosion if a lithium bat-
tery is incorrectly replaced. Replace only
with the same or equivalent type.
Recommended battery: CR2025 or equivalent.
4
Close the lid securely.
5. Press the
button, then the
button two or three times to check the key-
fob operation.
If the battery is removed for any reason
other than replacement, perform step 5.
An improperly disposed battery can
hurt the environment. Always confirm
local regulations for battery disposal.
The keyfob is water-resistant; how-
ever, if it does get wet, immediately
wipe completely dry.
The operational range of the keyfob
extends to approximately 33 ft (10 m)
from the vehicle. This range may vary
with conditions.
LDI0484
8-24 Maintenance and do-it-yourself