Filter
Top Products
“Record”
᭺
A
The system announces “Recording” and a tone
sounds, signaling you to begin.
Speak the information you wish to record clearly.
When you are done, press the
or
button on the steering wheel.
A tone sounds and the system announces
“Memo recorded.” Another tone sounds to end
the VR session.
If thememo padis full,the systemasks if youwish
to record over the oldest memo.
“Play”
᭺
B
The system plays back all the memos in the order
of newest to oldest. The system ends the VR
session.
If there are no memos recorded, the system an-
nounces “No messages to play.” The system
ends the VR session.
“Delete”
᭺
C
The Delete command erases all memos. The
system asks you to confirm this action before
deleting all memos.
“Setup”
Main Menu
“Setup”
“Pair Phone”
᭺
A
“List Phone”
᭺
B
“Select Phone”
᭺
C
“Change Priority”
᭺
D
“Delete Phone”
᭺
E
“Select Ringtone”
᭺
F
“Bluetooth Off”
᭺
G
Use the Setup command to change options as-
sociated with the Bluetoothா Hands-Free Phone
System.
“Pair phone”
᭺
A
Use the Pair Phone command to pair a compat-
ible phone to the Bluetoothா Hands-Free Phone
System.
NOTE:
The pairing procedure must be performed
when the vehicleis stationary. If the vehicle
starts moving during the procedure, the
procedure will be cancelled. Also, see
“Pairing procedure” in this section for ad-
ditional information.
Up to 5 phones can be paired. If you try to pair a
sixth phone, the system announces that you must
first delete one phone or replace an existing
phone.
If you try to pair a phone that has already been
paired to your vehicle’s system, the system an-
nounces the name the phone is already using.
The pairing procedure will then be cancelled.
When prompted by the system, choose from the
following commands:
● “New phone” — Refer to “Pairing proce-
dure” in this section.
● “Replace phone” — The system announces
the names of the phones already paired and
asks which you would like to replace.
Once you say the name of the phone you
wish to replace, the pairing procedure will
begin. Refer to “Pairing procedure” in this
section.
● “List phone” – See the description below.
“List phone”
᭺
B
Use the List Phone command to hear the names
of the phones currently paired. If no phones are
paired, the system announces, “No paired
phones to list.” The system then ends the VR
session.
Display screen, heater, air conditioner, audio and phone systems 4-77