Filter
Top Products
F10
66
How do I install NavDesk onto my computer?
Note: Before you begin:
Ensure that your computer meets the minimum system requirements for NavDesk, especially:
i. Ensure that Internet Explorer 6 or higher is installed on your computer before you install NavDesk, even if it is not your default browser.
ii. Windows XP users, ensure that Windows XP Service Pack 2 or higher has been applied before you install NavDesk.
1. Close all programs on your computer.
2. Insert the NavDesk Application Installer DVD into your computer DVD drive.
The NavDesk installer will start.
If your computer does not automatically launch the DVD, start the installation manually:
Start
Run.
Type D:\Install.exe where “D” is the letter assigned to your DVD drive, then click OK.
3. Select your preferred language for NavDesk.
4. Click Install NavDesk.
5. Follow the screen prompts to install NavDesk:
Review and accept the Licence Agreement for NavDesk when prompted.
Select a destination folder for NavDesk when prompted.
When the installation has finished, click Finish.
NavDesk will open.
6. If prompted to connect your Navman to your computer, complete the following:
Plug the large end of the USB cable directly into a USB port on your computer (not a USB hub) and plug
the small end into the USB Socket (
) on the bottom of your Navman.
Tip: Where possible, plug the USB cable into a USB port at the back of your computer.
Press and hold to turn your Navman on.
When the following screen displays on your Navman, click Next:
7. If prompted to update your Navman software, follow the on-screen prompts.
You are now ready to use NavDesk to install maps to your Navman.