Multiquip SP403030 Automobile Parts User Manual


 
PAGE 38 — MQ SP4030 SAW • OPERATION MANUAL — REV. #0 (01/22/09)
LOADING, UNLOADING AND TRANSPORTING THE
SAW
Loading and Unloading
Tie-Down Points
The saw is provided with holes at each corner of the lower
frame for easy tie-down during transportation. See Figure 32.
LOADING AND TRANSPORTING
WARNING
When LOADING, UNLOADING, or when on a STEEP
SLOPE, the engine MUST BE at 1800 RPM or above
to prevent loss of control.
CAUTION
NEVER tie the back end of the saw down by strapping
across the handlebars.
CAUTION
The use of tie-downs to secure the saw during
transportation is highly recommended. ALWAYS secure
the saw during transportation to prevent unwanted
movement or shifting that could result in equipment
damage or injury to personnel.
WARNING
AVOID INJURY!
Stay clear of the saw while it is being hoisted.
To avoid possible damage to the saw, use approved
rigging (minimum 3000 lb. test) when hoisting the saw.
Figure 32. Tie-Down Points
Figure 33. Lifting Point
Figure 34. Night Light
Lifting Point
The convenient single point for lifting the saw with a hoist is
located above the engine (Figure 33).
Night Light
The night light, (Figure 34),can be used on either side of the
saw and can be extended and rotated for best illumination of
the cutting area. Aim the light then lock it in position by
tightening the lock knobs. The light can be removed for storage
by loosening the lock knobs, disconnecting the light cord and
sliding the light bar out of the saw.
To turn Lights ON, push the rocker-style switch located on the
instrument panel forward. To turn Lights OFF, push rocker switch
backward.