Filter
Top Products
MQ SP4030 SAW • OPERATION MANUAL — REV. #0 (01/22/09) — PAGE 11
RULES AND REGULATIONS
NEVER use fuel as a cleaning agent.
ALWAYS store the equipment in a clean, dry location
out of the reach of children.
NEVER run engine without air cleaner or filter. Service
air cleaner at recommended service intervals to prevent
egine damage. Severe engine damage may occur.
NEVER leave the equipment unattended with the engine
running. Turn off engine when unattended.
CAUTION must always be observed while servicing this
equipment. Rotating parts can cause injury if contacted.
ALWAYS keep the work area well-organized.
Keep the saw clean. It will perform better and last longer.
ALWAYS check to make sure that the cutting area is
clear before starting the engine. ALWAYS clear the
cutting area of any debris, tools, etc. that would
constitute a hazard while the saw is in operation.
Keep all inexperienced and unauthorized people clear of
the cutting area when operating the saw.
No one other than the operator is to be in the working
area when the saw is in operation.
NEVER allow passengers or riders on the saw during
operation or transportation.
Make certain all protective guards are securely in place
BEFORE operating the saw. This saw is supplied with a
blade guard, blade flange guard and a belt guard.
NEVER place your
feet
or
hands
inside the guards while
starting or operating this equipment.
DO NOT go near rotating parts, (blades,
belts, pulleys or wheels), while engine is
running.
Moving Parts – Shut down the engine before performing
service or maintenance functions. Contact with moving
parts can cause serious injury.
NEVER touch the hot exhaust manifold,
muffler or cylinder. Allow these parts to cool
before servicing the saw. Contact with
hot!
components can cause serious burns.
Verify the engine start switch is set to the OFF position
before installing a blade.
Use proper blades and follow the blade manufacturer’s
recommendations. Match the blade RPM (blade shaft
RPM) to the recommended blade surface feet per minute.
(SFPM).
Ensure the 5/8" blade-mounting bolt is tightened to 125-
175 foot lbs. of torque.
NEVER leave the machine
unattended
while running.
Ensure brakes are applied when leaving or when using
on a slope. This saw utilizes a brake system where the
brakes are automatically applied when the engine is
stopped.
Start engine with the control handle in the NEUTRAL
position to prevent unexpected saw movement.
Do not start engine on a sloping surface to prevent
unexpected loss of control.
DO NOT use on excessive slopes or on extremely
uneven surfaces.
If the saw must be parked on a slope and engine turned
off, ensure the parking brake is engaged and holds the
saw safely in place. Turning the saw across the angle of
the slope will help prevent accidental downhill movement.
Block the saw as well when leaving.