Filter
Top Products
•
Loosen the two fixings on the cable clamp.
•
Pull the cable out through the cable gland.
Replacement
Re-fitting is the reverse of the removal procedure.
•
Feed the new cable(s) through the cable
gland.
•
Connect the cable(s) including the earth
lead.
•
Tighten the cable retaining clamp.
•
Take care not to damage the sealing
gasket on the termination box when
replacing the cover.
•
Replace the fixings according to the record
made when they were removed.
•
Tighten the four M3 fixings to a torque of
0.7 Nm.
Page 10
Chapter 3 ServoTube 38 Installation Guide
Maintenance
POWER CABLE
M3 FIXING SCREWS (4 OFF)
SENSOR CABLE
POD LID
POD
MICRO CONNECTOR
ON PCB, PL1
SENSOR CABLE
POWER CABLE
CABLE
GLAND
SCREW TERMINAL
CONNECTOR, TB1
Figure 3.1 - Power and Sensor cable connection details in the pod