Filter
Top Products
ENGINE <4D6> -
Crankshaft Oil Seal
11C-21
REMOVAL SERVICE POINT
A
A
"
TRANSMISSION ASSEMBLY REMOVAL
<M/T>:
Refer to GROUP 22.
Caution
Do not remove the flywheel mounting bolt shown by the
arrow. If this bolt Is removed, the flywheel will become
out of balance and damaged.
<A/T>:
Refer to GROUP 23.
A
B
"
ADAPTER PLATE/FLYWHEEL <M/T>/DRIVE
PLATE <A/T> REMOVAL
Use the special tool to secure the flywheel or drive plate,
and remove the bolts.
INSTALLATION SERVICE POINTS
"
A
A
CRANKSHAFT REAR OIL SEAL INSTALLATION
1. Apply a small mount of engine oil to the entire
circumference of the oil seal lip.
2. Install the oil seal by tapping it as far as the chamfered
position of the oil seal case as shown in the illustration.
"
B
A
DRIVE PLATE <A/T>/FLYWHEEL <M/T>/ADAPTER
PLATE INSTALLATION
1. Clean off all sealant, oil and other substances which are
adhering to the threaded bolts, crankshaft thread holes
and the flywheel or drive plate.
2. Apply oil to the bearing surface of the flywheel or drive
plate bolts.
3. Apply oil to the crankshaft thread holes.
4. Apply sealant to the threaded mounting holes.
Specified sealant: 3M Stud locking 4170 or equivalent
5. Use the special tool to hold the flywheel or drive plate
in the same manner as removal, and install the bolt.
<M/T>
Flywheel
Bolt
MD998781
Crankshaft
rear oil seal
MD990938
MD998776
Crankshaft