Filter
Top Products
ENGINE <6A1> -
Camshaft and Camshaft Oil Seal
11B-17
A
B
"
CAMSHAFT SPROCKET REMOVAL
A
C
"
ROCKER ARM AND SHAFT ASSEMBLY
REMOVAL
1. Install the special tools as shown in the illustration so
that the lash adjusters will not fall out.
2. Loosen the rocker arm and shaft assembly mounting bolt,
and then remove the rocker arm and shaft assembly with
the bolt still attached.
Caution
Never disassemble the rocker arm and shaft
assembly.
INSTALLATION SERVICE POINTS
"
A
A
CAMSHAFT INSTALLATION
Set the camshaft dowel pins so that they are in the position
shown in the illustration.
Caution
Do not mistake the camshafts for the front bank and the
rear bank. The camshaft for the rear bank has a slit with
a width of approximately 4 mm on its rear end.
"
B
A
CAMSHAFT OIL SEAL INSTALLATION
1. Apply engine oil to the camshaft oil seal lip.
2. Use the special tool to press-fit the camshaft oil seal.
MB990767
MD998715
MD998443
Approx.
35
_
Approx.
35
_
<Front bank side> <Rear bank side>
Dowel
pin
Dowel
pin
MD998713
MD991559
MD998713
<Front bank side>
<Rear bank side>