Filter
Top Products
ENGINE <4D6> -
Camshaft and Camshaft Oil Seal
11C-17
REMOVAL SERVICE POINT
A
A
"
CAMSHAFT SPROCKET REMOVAL
INSTALLATION SERVICE POINTS
"
A
A
CAMSHAFT BEARING CAP INSTALLATION
The cap numbers are embossed on the top surface of the
bearing caps, so install in the order of the numbers. However,
no numbers are embossed on bearing caps 1 and 5.
"
B
A
ROCKER ARM AND SHAFT ASSEMBLY
INSTALLATION
1. Install the rocker arm an d shaft assembly to the bearing
caps.
2. Set the rocker arm springs into the bearing cap indents.
3. Check the valve clearance and adjust if necessary.
(Refer to P.11C-8.)
"
C
A
CAMSHAFT OIL SEAL INSTALLATION
1. Apply a small amount of engine oil to the entire
circumference of the oil seal lip and camshaft.
2. Use the special tool to tap in the oil seal.
NOTE
The oil seal should be tapped in until the distance from
the end of the camshaft to the en d of the oil seal is
as shown in the illustration.
"
D
A
CAMSHAFT SPROCKET INSTALLATION
Use the special tool to stop the camshaft sprocket from turning
in the same way as was done during removal, and then tighten
the bolts to the specified torque.
Tightening torque: 88 Nm
MB990767
MD998719 or
MD998754
Camshaft sproket
side
Cap No.
Indent
Bearing cap
Oil seal
Camshaft
MD998364
5.5 mm