Filter
Top Products
ENGINE <6A1> -
Timing Belt
11B-28
"
B
A
TIMING BELT INSTALLATION
1. Check that the timing marks of the both camshaft
sprockets and the crankshaft sprocket are aligned.
NOTE
In this condition, the No.1 cylinder will be in th e
compression top dead centre position.
2. Install the timing belt so that there is no slackness on
the tension sides of the belt (A, B, C and D).
Caution
Be careful not to damage the teeth of the timing belt
against the edges of the camshaft sprocket when
installing the timing belt.
NOTE
If reusing the old timing belt, install it so that the arrow
made on the belt during removal is pointing in the direction
of rotation (clockwise).
3. Set the tensioner pulley so that the pin holes are at the
bottom, press the tensioner pulley lightlyagainst the timing
belt, and then provisionally tighten the fixing bolt.
4. Apply force to the rear bank side camshaft sprocket in
the direction of the arrow to apply tension to the tension
sides (A, B, C and D), and check that all of the timing
marks are aligned at this time.
Camshaft
sprocket
Crank-
shaft
sprocket
Timing
marks
Camshaft
sprocket
Rocker cover
Rocker cover
Tension side C
Tension side D
Rear
bank
side
camshaft
sprocket
Tension side A Tension side B
Fixing bolt
Pin holes