Mitsubishi Electronics QJ72LP25G Automobile Electronics User Manual


 
115
APPENDICES
A
Appendix 4 Special Register (SD) for MELSECNET/H (MELSECNET/10 Mode) Remote I/O Station
*1 This applies to Universal model QCPUs except for the Built-in Ethernet port QCPU.
(2) System information
SD105
CH1
transmission
speed setting
(RS-232)
Stores a
transmission
speed set in
GX Developer.
96: 9600bps, 192: 19.2kbps,
384: 38.4kbps, 576: 57.6kbps,
1152: 115.2kbps
The data of the RS-232 connection is used for any other connection.
(When an external device is not connected, the default is 1152).
SNew
Qn(H)
QnPH
QnPRH
QnU
*1
Rem
No. Name Meaning Explanation
Set by
(When Set)
Corres-
ponding
ACPU
D9
Corres-
ponding
CPU
SD200
Status of
switch
Status of CPU
switch
This register stores the status of the remote I/O module switch in the
following bit pattern.
1) Remote I/O module switch status
Always 1: STOP
S
(Always)
New
Rem
This register stores the status of the CPU module switches in the
following bit pattern.
1) CPU switch status
0: RUN
1: STOP
2: L.CLR
2) Memory card switch: Always OFF
3) DIP switch
B8 through B12 correspond to SW1 through SW5 of system
setting switch 1. 0: OFF, 1: ON. BD through BF are empty.
S
(Every END
processing)
Qn(H)
QnPH
QnPRH
This register stores the status of the CPU module switches in the
following bit pattern.
1) CPU switch status
0: RUN
1: STOP
2) Memory card switch: Always OFF
Q00J/
Q00/Q01
This register stores the status of the CPU module switches in the
following bit pattern.
1) CPU switch status
0: RUN
1: STOP
2) Memory card switch: Always OFF
S
(when RUN/
STOP/
RESET
switch
changed)
QnU
No. Name Meaning Explanation
Set by
(When Set)
Corres-
ponding
ACPU
D9
Corres-
ponding
CPU
B15 B4 B3 B0
1)
Empty
B15 B12B11 B8 B7 B4B3 B0
1)2)
Empty
3)
B15 B6 B4 B3 B0
1)2)
Empty
B5
B15 B6 B4 B3 B0
1)2)
Empty
B5