Filter
Top Products
58
Getting started
Parking and locking
Turning off the engine
̈ Place the gear selector lever in
position P.
Turning off with the SmartKey
̈ Turn the SmartKey in the starter switch
(
୴ page 36) to position 0 and remove
it.
̈ Press the seat belt release button
(
୴ page 45).
Allow the retractor to completely re-
wind the seat belt by guiding the latch
plate.
̈ After exiting the vehicle, press the lock
button ‹ on the SmartKey
(
୴ page 34).
All turn signal lamps flash three times.
The locking knobs on the doors move
down. The anti-theft alarm system is
armed.
i
Always set the parking brake in addi-
tion to shifting to position P.
On slopes, turn the front wheels to-
wards the road curb.
i
The immobilizer is activated.
i
The SmartKey can only be removed
from the starter switch with the gear
selector lever in position P.
i
With the SmartKey removed and the
driver’s door open, a warning sounds if
the vehicle’s exterior lamps are not
switched off.
i
Opening a door causes the windows on
that side of the car to open slightly.
They will return to the up position when
the door is closed.
Warning! G
To prevent possible personal injury, always
keep hands and fingers away from the door
openings when closing the doors. Be espe-
cially careful when small children are
around.
Before closing doors, make sure that there
is no possibility of someone getting caught
in a door during closing.