Filter
Top Products
195
Controls in detail
Power windows
Fully closing the windows
(Express-close)
̈ Pull switch 1 or 2 past the resis-
tance point and release.
The corresponding window closes com-
pletely.
If the upward movement of the window is
blocked during the closing procedure, the
window will stop and open slightly.
Stopping windows
̈ Press or pull the respective switch
again.
Closing the windows with the
SmartKey with KEYLESS-GO*
̈ Press and hold lock button at door
(
୴ page 60) until the side windows are
closed.
Synchronizing power windows
The power window must be resynchro-
nized each time
ț after the battery has been disconnect-
ed
ț if the power windows cannot be fully
opened (Express-open) or closed
(Express-close)
Synchronizing the power windows
̈ Switch on ignition.
̈ Pull the power window switches until
the side windows are closed.
Hold the switches for approximately
one second.
The power windows are synchronized.
Warning G
Driver’s door only:
If within five seconds the switch is again
pulled past the resistance point and re-
leased, the automatic reversal will not
operate.
Warning! G
When closing the windows make sure that
there is no danger of anyone being harmed
by the closing procedure.
The windows will not automatically re-open
if blocked during convenience closing.
If potential danger exists, proceed as fol-
lows:
ț Release the lock button.
ț Pull on the door handle and hold firmly.
The side windows open for as long as
the door handle is held but the door not
opened.