Filter
Top Products
54
Getting started
Driving
Single wipe
̈ Press the combination switch briefly in
direction of arrow 1.
The windshield wipers wipe one time
without washer fluid.
Wiping with windshield washer fluid
̈ Push the combination switch in direc-
tion of arrow 1 past the resistance
point.
The windshield wipers operate with
washer fluid.
For information on filling up the washer
reservoir, see “Windshield washer system
and headlamp cleaning system”
(
୴ page 278).
!
If anything blocks the windshield
wipers (leaves, snow, etc.), switch
them off immediately.
ț For safety reasons,
ț turn off the engine by turning
the SmartKey to position 0 and
withdraw the SmartKey from
the starter switch
or
ț turn off the engine by pressing
the KEYLESS-GO* start/stop
button and open the driver’s
door (with the driver’s door
open, the starter switch is in po-
sition 0, same as with the
SmartKey removed from the
starter switch)
before attempting to remove any
blockage.
ț Remove blockage.
ț Turn the windshield wipers on
again.
If windshield wipers fail to function at
all in switch position I,
ț set the combination switch to the
next higher wiper speed
ț have the windshield wipers
checked at the nearest authorized
Mercedes-Benz Center