Filter
Top Products
Disconnecting the jumper cables
X
Disconnect the jumper cables in reverse
order, starting with jump start terminal 4
(Y page 30).
X
Install the jump start terminal cover
(Y page 28).
X
Install the high-voltage battery cover
(Y page 27).
X
Close the hood.
X
Drive the vehicle for some time in order to
charge the 12-volt battery and the high-
voltage battery.
Towing the vehicle
i
For information on towing and
transporting the vehicle refer to the
Operator’s Manual.
G
Warning!
When you depress the brake pedal for the first
time when towing, less brake pedal pressure
is required and the brake pedal travel is longer
than usual. The same applies if a malfunction
occurs, for example when the vehicle system
voltage is too low. If required, you have to
depress the brake pedal further. Adapt your
speed and driving accordingly.
Depress the brake pedal fully and release it
again before towing. When all necessary
systems are operational again, the required
brake pedal pressure and the brake pedal
travel are back to normal.
Practical hints
31
221_ZA; 1; 21, en-US
d2ureepe, Version: 2.11.8.1
2009-05-13T13:56:31+02:00 - Seite 31
Z