Mercedes-Benz 2010 S 400 Hybrid Automobile User Manual


 
Automatic HYBRID system switch-off
The HYBRID system switches off
automatically if
R
the Supplemental Restraint System (SRS)
activates the restraint systems in an
accident
R
a short circuit in the HYBRID system is
detected
R
a plug connection of the HYBRID system is
disconnected
These measures help to prevent you from
coming into contact with high voltage.
High-voltage battery
G
Warning!
The high-voltage battery of the HYBRID
system is located in the engine compartment
on the passenger side of the front wall. When
the pressure inside the high-voltage battery
exceeds a certain value, for example in case
of a vehicle fire, inflammable gas will escape
via a duct. The inflammable gas escapes to an
area close to the passenger-side front wheel.
This prevents the high-voltage battery from
exploding.
Stay away from this area of the vehicle.
Driving safety systems
ABS (Antilock Brake System)
Braking
When the ABS engages during braking, the
ABS/ESC warning lamp ÷ in the
instrument cluster (Y page 14) flashes. The
brake pedal will pulsate only in certain
situations, for example on a slippery road.
i
For more information on the ABS, refer to
the Operator's Manual.
RBS (Recuperative Brake System)
The RBS supports you while braking by
electronic controlled brake boost and allows
for regeneration of braking energy. RBS must
be activated when the vehicle is parked each
time before driving off.
X
Make sure the automatic transmission is in
park position P.
X
Switch on the ignition.
X
Apply the brake pedal fully and release it.
The RBS is activated.
While you activate the RBS, less brake pedal
pressure than usual is required and the brake
pedal travel is longer. When you release the
brake pedal, the brake pedal travel is as usual
again.
For more information on the RBS, see
(Y page 12).
G
Warning!
If the RBS malfunctions, the yellow RBS
warning lamp é and/or the red brake
warning lamp $ (USA only) or J
(Canada only) in the instrument cluster comes
on. Read and observe the messages in the
multifunction display that may appear. Find
the subentry “Malfunction” of the entry “RBS
(Recuperative Brake System)” in the index of
this manual and follow the steps described in
that section.
G
Warning!
If the RBS malfunctions, less brake pedal
pressure than usual may be required and the
brake pedal travel may be longer. The brake
system still functions with full effectiveness.
If required, you have to depress the brake
pedal further. Adapt your speed and driving
accordingly.
G
Warning!
Have work on the RBS, e.g. brake pad
replacement, carried out by qualified
technicians only.
10
Safety and security
221_ZA; 1; 21, en-US
d2ureepe, Version: 2.11.8.1
2009-05-13T13:56:31+02:00 - Seite 10