Filter
Top Products
Vehicle status messages in the
multifunction display
Notes
Warning and malfunction messages appear in
the multifunction display located in the
instrument cluster. Certain warning and
malfunction messages are accompanied by
an audible signal.
High-priority messages are shown in red in
the multifunction display. Messages of lower
priority are also shown in yellow or white.
Address these messages accordingly and
follow the additional instruction given in this
Supplemental Operating Instructions Booklet
and in the Operator’s Manual.
G
Warning!
All categories of messages contain important
information which should be taken note of
and, where a malfunction is indicated,
addressed as soon as possible at an
authorized Mercedes-Benz Center.
Failure to repair the condition noted may
cause damage not covered by the Mercedes-
Benz Limited Warranty, or result in property
damage or personal injury.
G
Warning!
No messages will be displayed if either the
instrument cluster or the multifunction
display is inoperative.
As a result, you will not be able to see
information about your driving conditions,
such as
R
speed
R
outside temperature
R
warning/indicator lamps
R
malfunction/warning messages
R
failure of any systems
Driving characteristics may be impaired.
If you must continue to drive, do so with added
caution. Contact an authorized Mercedes-
Benz Center as soon as possible.
On the pages that follow, you will find a
compilation of the warning and malfunction
messages specific to the HYBRID system. For
all other warning and malfunction messages,
refer to the Operator’s Manual.
Clearing display messages
Some display messages with low priority are
cleared from the multifunction display after
several seconds. Other display messages
remain displayed in the multifunction display
until you clear them manually.
Certain messages of high priority cannot be
cleared from the multifunction display. Such
messages will appear in the multifunction
display until the causes for these messages
have been repaired.
Use the buttons on the multifunction steering
wheel.
X
Clear the messages using button a or
%.
Certain messages are stored in the vehicle
status message memory. For information
on calling up vehicle malfunction, warning
and system status messages stored in
memory, refer to the Operator’s Manual.
20
Practical hints
221_ZA; 1; 21, en-US
d2ureepe, Version: 2.11.8.1
2009-05-13T13:56:31+02:00 - Seite 20