Filter
Top Products
309
Operation
Tires and wheels
̈ Switch on the ignition (୴ page 38).
̈ Press button è or ÿ on the mul-
tifunction steering wheel repeatedly
until the standard display menu ap-
pears in the multifunction display
(
୴ page 139).
̈ Press the j or k button repeat-
edly until you see the flowing message:
Tire Pressure
Monitor Active
Menu: R-Button
̈ Press the reset button (୴ page 27).
The following message will appear in
the multifunction display:
Restart
tire pressure
monitor?
Cancel
Yes
̈ Press the æ button.
The following message will appear in
the multifunction display:
Tire Pressure
Monitor
Restarted
After driving a few minutes the current
tire inflation pressure values are ac-
cepted as reference pressures and
then monitored.
If you wish to cancel activation:
̈ Press the ç button.
Checking tire inflation pressure elec-
tronically with the Advanced Tire Pres-
sure Monitoring System* (Advanced
TPMS*), (Canada only)
The TPMS only functions on wheels that
are equipped with the proper electronic
sensors. It monitors the tire inflation pres-
sure, as selected by the driver, in all four
tires. A warning is issued to alert you to a
decrease in pressure in one or more of the
tires.
i
Restart the TPMS after adjusting the tire in-
flation pressure to the inflation pressure recom-
mended for the vehicle operating condition. Tire
pressure should only be adjusted on cold tires.
Observe the recommended tire inflation pres-
sure on the Tire and Loading Information placard
on the driver’s door B-pillar (
୴ page 296). Some
vehicles may have supplemental tire inflation
pressure information for driving at high speeds
(
୴ page 302) or for vehicle loads less than the
maximum loaded vehicle condition
(
୴ page 302). If such information is provided, it
can be found on the inside of the fuel filler flap
(
୴ page 283).
i
This device complies with RSS-210 of Indus-
try Canada. Operation is subject to the following
two conditions:
(1) This device may not cause interference, and
(2) this device must accept any interference re-
ceived, including interference that may
cause undesired operation of the device.
Any unauthorized modification to this device
could void the user’s authority to operate the
equipment.