Filter
Top Products
94
Safety and Security
Occupant safety
2 Hook
3 Anchorage ring
̈ Swing rear seat backrest to the rear un-
til it engages.
̈ Check the rear seat backrest to be
locked in its upright position
(
୴ page 412).
Once the top tether anchorage hook is
attached, the child restraint itself can be
secured.
̈ Install the child restraint system and
tighten the top tether strap according
to the child restraint manufacturer’s in-
structions.
Child seat anchors - LATCH type
This vehicle is equipped with two LATCH
(L
ower Anchors and Tethers for CHildren)
type anchors (at each of the outer rear
seats) for the installation of a “LATCH”
child seat with the matching mounting fit-
tings.
The anchors are located behind an uphol-
stery blend.
1 Indicates the position of the anchors
2 Anchors
̈ Lift up upholstery blend to access the
anchors 2.
̈ Install child seat according to the
manufacturer’s instructions.
!
Make sure the seat belt for the center seat
can operate freely with a child seat installed.
i
Non-LATCH type child seats may also be
used and can be installed using the vehicle’s
seat belt system (
୴ page 88). Install child seat
according to the manufacturer’s instructions.
୴୴