Filter
Top Products
248
Controls in detail
Panorama roof with power tilt/sliding panel*
Opening and closing the panorama roof
with power tilt/sliding panel
̈ To open, close, raise, or lower the
tilt/sliding panel, move the roof panel
switch to resistance point in the re-
quired direction of arrows 1 to 4.
Release the roof panel switch when the
tilt/sliding panel has reached the de-
sired position.
Fully opening (Express-open) the pan-
orama roof with power tilt/sliding pan-
el
̈ Move the roof panel switch past the re-
sistance point in direction of arrow 1
and release.
The tilt/sliding panel opens
completely.
Stopping the panorama roof with power
tilt/sliding panel during Express-open
̈ Move the roof panel switch in any di-
rection.
Synchronizing the panorama roof with
power tilt/sliding panel
The tilt/sliding panel must be
synchronized
ț after the battery has been
disconnected or discharged
ț after the tilt/sliding panel has been
closed manually (
୴ page 439)
ț after a malfunction
ț if the tilt/sliding panel does not open
smoothly
̈ Remove the fuse from the main fuse
box (
୴ page 469).
̈ Reinsert the fuse in the main fuse box.
̈ Switch on the ignition (୴ page 37).
̈ Move and hold the roof panel switch in
direction of arrow 2 until the roller
sunblinds are fully closed.
̈ Keep holding the roof panel switch in
direction of arrow 2 for approximately
1 second.
̈ Move and hold the roof panel switch in
direction of arrow 1 until the roller
sunblinds are fully opened.
̈ Keep holding the roof panel switch in
direction of arrow 1 for approximately
1 second.
̈ Move and hold the roof panel switch in
direction of arrow 3 until the tilt/slid-
ing panel is fully raised.
̈ Keep holding the roof panel switch in
direction of arrow 3 for approximately
1 second.
̈ Move and hold the roof panel switch in
direction of arrow 2 until the tilt/slid-
ing panel is fully closed.
̈ Keep holding the roof panel switch in
direction of arrow 2 for approximately
1 second.
̈ Check the Express-open feature of the
tilt/sliding panel (
୴ page 248).
If the tilt/sliding panel opens com-
pletely, the roof is synchronized. Other-
wise repeat the above steps.