Filter
Top Products
59
Getting started
Parking and locking
Releasing seat belts
̈ Press the seat belt release button
(
୴ page 47).
Allow the retractor to completely
rewind the seat belt by guiding the
latch plate.
Locking
̈ After exiting the vehicle, press the lock
button ‹ on the SmartKey
(
୴ page 38).
With the hood, trunk and all doors
closed, all turn signal lamps flash three
times. The anti-theft alarm system is
armed.
For more information, see “Locking and
unlocking” (
୴ page 96).
!
Make sure the seat belt retracts fully so
that the seat belt and/or latch plate
cannot get caught or pinched in the
door or in the seat mechanism. This
can damage the seat belt and impair
the effectiveness of the seat belt,
and/or cause damage to the door
and/or door trim panel. Such damage
is not covered by the Mercedes-Benz
Limited Warranty.
Damaged seat belts must be replaced.
Contact an authorized Mercedes-Benz
Center.
Warning! G
To prevent possible personal injury, always
keep hands and fingers away from the door
openings when closing the doors. Be espe-
cially careful when small children are
around.
Before closing doors, make sure there is no
possibility of someone getting caught in a
door during closing.
Warning! G
When leaving the vehicle, always remove the
SmartKey from the starter switch, take it
with you, and lock the vehicle. Do not leave
children unattended in the vehicle, or with
access to an unlocked vehicle. Unsuper-
vised use of vehicle equipment may cause
an accident and/or serious personal injury.
i
With the SmartKey removed from the
starter switch and the driver’s door
open, a warning sounds and the mes-
sage
Turn off lamps
appears in the
multifunction display if the vehicle’s ex-
terior lamps are not switched off.