Filter
Top Products
61
Getting started
Parking and locking
Turning off engine
̈ Manual transmission: Move the gear-
shift lever into first or reverse gear.
̈ Automatic transmission*: Place the
gear selector lever in position P.
̈ Turn the SmartKey in the starter switch
to position 0 and remove the SmartKey
from the starter switch.
The immobilizer is activated.
̈ Press the seat belt release button
(
୴ page 49).
̈ Guide the latch plate to allow the re-
tractor to completely rewind the seat
belt.
i
Always set the parking brake in addi-
tion to shifting into first or reverse gear
(automatic transmission*: gear selec-
tor lever in position P).
On slopes, turn the front wheels to-
wards the road curb.
i
Vehicles with automatic transmission*:
The SmartKey can only be removed
from the starter switch with the gear
selector lever in position P.
!
Make sure the seat belt retracts fully so
that the seat belt and/or latch plate
cannot get caught or pinched in the
door or in the seat mechanism. This
can damage the seat belt and impair
the effectiveness of the seat belt,
and/or cause damage to the door
and/or door trim panel. Such damage
is not covered by the Mercedes-Benz
Limited Warranty.
Damaged seat belts must be replaced.
Contact an authorized Mercedes-Benz
Center.
i
With the SmartKey removed from the
starter switch and the driver’s door
open, a warning sounds if the parking
lamps or low beam headlamps are
switched on (
୴ page 110).
The message
Turn off lights
appears
in the multifunction display.