![](http://pdfasset.owneriq.net/a/8d/a8d8c942-80f6-4d1a-a852-14736d143f69/a8d8c942-80f6-4d1a-a852-14736d143f69-bg121.png)
289
Operation
Tires and wheels
̄ Tires and wheels
See your authorized Mercedes-Benz Cen-
ter for information on tested and recom-
mended rims and tires for summer and
winter operation. They can also offer ad-
vice concerning tire service and purchase.
Retreaded tires are not tested or recom-
mended by Mercedes-Benz, since previous
damage cannot always be recognized on
retreads. Mercedes-Benz can therefore
not assure the operating safety of the vehi-
cle when such tires are used.
See your authorized Mercedes-Benz Cen-
ter for information on tested and recom-
mended rims and tires for summer and
winter operation.
Important guidelines
ț Only use sets of tires and rims of the
same type and make.
ț Tires must be of the correct size for the
rim.
ț Break in new tires for approximately
60 miles (100 km) at moderate
speeds.
ț Regularly check the tires and rims for
damage. Dented or bent rims can
cause tire pressure loss and damage to
the tire beads.
ț If vehicle is heavily loaded, check tire
pressure and correct as required.
ț Do not allow your tires to wear down
too far. Adhesion properties on wet
roads are sharply reduced at tread
depths under
1
⁄
8
in (3 mm).
ț When replacing individual tires, you
should mount new tires on the front
wheels first (on vehicles with
same-sized wheels all around).
Warning! G
Replace rims or tires with the same designa-
tion, manufacturer and type as shown on the
original part. See your authorized
Mercedes-Benz Center for further informa-
tion. If incorrectly sized rims and tires are
mounted:
ț The wheel brakes or suspension compo-
nents can be damaged
ț The correct operating clearance of the
wheels and the tires are no longer guar-
anteed
Warning! G
Worn, old tires can cause accidents. If the
tire tread is badly worn, or if the tires have
sustained damage, replace them.
When replacing rims, use only genuine
Mercedes-Benz wheel bolts specified for the
particular rim type. Failure to do so can re-
sult in the bolts loosening and possibly an
accident.