Filter
Top Products
69
Safety and Security
Occupant safety
Child seat anchors – LATCH-type
This vehicle is equipped with two LATCH-
(L
ower Anchors and Tethers for CHildren)
type anchors (at each of the outer rear
seats) for the installation of a LATCH-type
child seat with the matching mounting
fittings.
If a child seat is not installed, the
LATCH-type anchors can be folded back
between the seat cushion and the
backrest.
1 Anchors
2 Button
̈ Grip inner side of anchors 1 and fold
forward until they audibly lock in place.
̈ Install child seat according to the
manufacturer’s instructions.
To fold anchors back
̈ Press down button 2 on each anchor
and return anchor 1 to its catch.
i
The child seat must be firmly attached
in the right and left side anchors 1.
With a child seat installed in the left
rear seat, the seat belt for the center
seat occupied by a passenger must op-
erate freely. Guide seat belt between
its seat cushion mount and backrest
mount along outside of right side child
seat anchor.
i
Non-LATCH-type child seats may also
be used and can be installed using the
vehicle’s seat belt system. Install child
seat according to the manufacturer’s
instructions.
Warning! G
Children too big for child restraint systems
must ride in back seats using regular seat
belts. Position shoulder belt across chest
and shoulder, not face or neck. A booster
seat may be necessary to achieve proper
belt positioning for children from 41 lbs until
they reach a height where a lap/shoulder
belt fits properly without a booster.
Before installing the child seat, make sure
anchors 1 are folded out and locked in
place.
Install child seat according to manufactur-
er’s instructions.
୴୴