Filter
Top Products
201
Controls in detail
Power windows
̈ Turn SmartKey in the starter switch to
position 1 or 2.
Opening the windows
̈ Press switch 1 to 4 to the resistance
point.
The corresponding window will move
downwards until you release the
switch.
Closing the windows
̈ Pull switch 1 to 4 to the resistance
point.
The corresponding window will move
upwards until you release the switch.
Fully opening the windows
(Express-open)
̈ Press switch 1 to 4 past the
resistance point and release.
The corresponding window opens
completely.
Fully closing the windows
(Express-close)
̈ Pull switch 1 to 4 past the
resistance point and release.
The corresponding window closes
completely.
Stopping windows
̈ Press or pull respective switch again.
Warning! G
If you pull and hold the switch up when
closing the window, and upward movement
of the window is blocked by some obstruc-
tion including but not limited to arms, hands,
fingers, etc., the automatic reversal will not
operate.
!
If the upward movement of the window
is blocked during the closing
procedure, the window will stop and
open slightly.
Remove the obstruction, pull the
switch again past the resistance point
and release.
If the window still does not close when
there is no obstruction, then pull and
hold the switch again. The side window
will then close without the obstruction
sensor function
Warning! G
Driver’s door only:
If within five seconds you again pull the
switch past the resistance point and
release, the automatic reversal will not
function.