Filter
Top Products
235
Controls in detail
Useful features
Gate operator/Canadian programming
Canadian radio-frequency laws require
transmitter signals to “time-out” (or quit)
after several seconds of transmission
which may not be long enough for the
integrated signal transmitter to pick up the
signal during programming. Similar to this
Canadian law, some U.S. gate operators
are designed to “time-out” in the same
manner.
If you live in Canada or if you are having
difficulties programming a gate operator
(regardless of where you live) by using the
programming procedures, replace step 4
with the following:
Step 4:
̈ Continue to press and hold the
integrated signal transmitter button
(2, 3 or 4) while you press and
re-press (“cycle”) your hand-held
remote control transmitter 6 every
two seconds until the frequency signal
has been learned. Upon successful
training, the indicator lamp 1 will
flash slowly and then rapidly after
several seconds.
̈ Proceed with programming step 5 and
step 6 to complete.
Operation of integrated remote control
̈ Switch on ignition.
̈ Select and press the appropriate
integrated signal transmitter button
(2, 3 or 4) to activate the remote
controlled device.
The integrated remote control trans-
mitter continues to send the signal as
long as the button is pressed – up to
20 seconds.