Filter
Top Products
48
Getting started
Driving
High beam
̈ Push the combination switch forward.
The high beam symbol
A in the
instrument cluster lights up.
More information can be found in the
“Controls in detail” section (
୴ page 101).
Windshield wipers
The combination switch is on the left of the
steering column.
Combination switch
1 Single wipe
2 Switching on windshield wipers
̈ Make sure that the ignition is switched
on.
Switching on windshield wipers
̈ Turn the combination switch to the de-
sired position depending on the inten-
sity of the rain.
0 Windshield wipers off
I Intermittent wiping
II Normal wiper speed
III Fast wiper speed
i
To signal minor directional changes,
move combination switch to point of
resistance only and release. The turn
signal blinks three times.
i
Vehicles without rain sensor*: Fast
wiper speed III goes to setting II when
the vehicle is standing still.
Vehicles with rain sensor*: Intermittent
wiping interval dependent on wetness
of windshield. Wiping will not occur
with a door open.
S203 MY03_A.book Page 48 Tuesday, January 28, 2003 2:22 PM