Filter
Top Products
238
Operation
Engine compartment
Coolant level
The engine coolant is a mixture of water
and anticorrosion/antifreeze. To check
the coolant level, the vehicle must be
parked on level ground and the engine
must be cool.
The coolant expansion tank is located on
the passenger side of the engine compart-
ment.
1 Coolant expansion tank
̈ Using a rag, turn the cap slowly approx-
imately one half turn to the left to re-
lease any excess pressure.
̈ Continue turning the cap to the left and
remove it.
The coolant level is correct if the level
ț for cold coolant: reaches the black
top part of the reservoir
ț for warm coolant: is approx. 0.6 in
(1.5 cm) higher
̈ Add coolant as required.
̈ Replace and tighten cap.
More information on coolant can be found
in the “Technical data” section
(
୴ page 334).
Warning! G
In order to avoid any possibly serious burns:
ț Use extreme caution when opening the
hood if there are any signs of steam or
coolant leaking from the cooling system,
or if the coolant temperature display in-
dicates that the coolant is overheated.
ț Do not remove pressure cap on coolant
reservoir if engine temperature is above
194°F (90°C). Allow engine to cool
down before removing cap. The coolant
reservoir contains hot fluid and is under
pressure.
ț Using a rag, slowly open the cap approx-
imately ½ turn to relieve excess pres-
sure. If opened immediately, scalding
hot fluid and steam will be blown out un-
der pressure.
ț Do not spill antifreeze on hot engine
parts. Antifreeze contains ethylene gly-
col which may burn if it comes into con-
tact with hot engine parts.
S203 MY03_A.book Page 238 Tuesday, January 28, 2003 2:22 PM