Filter
Top Products
Black plate (94,1)
NOTE
In the following cases, the KEY warning light
(red) illuminates and the engine will not start.
l
The advanced key battery is dead.
l
The advanced key is out of operational
range.
l
The advanced key is placed in areas where
it is difficult for the system to detect the
signal (page 3-7).
l
A key from another manufacturer similar to
the advanced key is in the operational
range.
8. Turn the ignition switch to the ACC
position while pushing the start knob
in.
9. Turn the ignition switch from the ACC
position to the START position and
hold (up to 10 seconds at a time) until
the engine starts.
CAUTION
Do not try the starter for more than
10 seconds at a time. If the engine
stalls or fails to start, wait 10 seconds
before trying again. Otherwise, you
may damage the starter and drain
the battery.
10. After starting the engine, let it idle for
about 10 seconds.
NOTE
l
In extremely cold weather or after the
vehicle has not been driven in several days,
let the engine warm up without operating
the accelerator.
l
Whether the engine is cold or warm, it
should be started without use of the
accelerator.
Turning off the engine
1. Move the shift lever to the P position.
2. Turn the ignition switch from the ON
position to the ACC position.
NOTE
When the engine is turned off and the ignition
switch it turned from the ACC position to the
LOCK position, the KEYindicator light
(green) flashes in the instrument cluster for
about 30 seconds if the battery power of the
advanced key is low. Replace the battery with a
new one.
Refer to Battery Replacement (page 3-6).
3. Push in the start knob from the ACC
position and turn it to the LOCK
position.
CAUTION
When leaving the vehicle, make sure
the ignition switch is turned to the
LOCK position.
3-12
Knowing YourMazda
Advanced Keyless Entry and Start System
CX-9_8Z66-EA-08F_Edition1 Page94
Thursday, May 29 2008 10:7 AM
Form No.8Z66-EA-08F