Filter
Top Products
Black plate (381,1)
qClock
NOTE
When the trip computer is displayed, press the
CLOCK button to change the display to the
time.
When the ignition switch is in the ACC or
ON position, the time is displayed.
Without navigation system
Time setting
1. Press the CLOCK button until the beep
sounds and the displayed time flashes.
2. Press the H switch to set the hour.
3. Press the M switch to set the minutes,
then press the CLOCK button.
Switching between 12 and 24-hour
clock time
1. Press the audio control dial several
times until 12Hr and 24Hr clock time
are displayed.
2. Turn the audio control dial in either
direction, select the desired clock
setting, and press the audio control
dial. Press the dial while the preferred
clock time is flashing.
With navigation system
Refer to the separate manual
“NAVIGATION SYSTEM”.
NOTE
Minutes and seconds are adjusted by the GPS,
however, it is necessary to adjust hours under
the following conditions:
l
Driving across different time zones
l
Daylight saving time start and end
qAmbient Temperature Display
When the ignition switch is in the ON
position, press the OUTSIDE switch
(page 6-6) to display the ambient
temperature.
NOTE
l
Under the following conditions, the ambient
temperature display may differ from the
actual ambient temperature depending on
the surroundings and vehicle conditions:
l
Significantly cold or hot temperatures.
l
Sudden changes in ambient temperature.
l
The vehicle is parked.
l
The vehicle is driven at low speeds.
l
Press the OUTSIDE switch a few seconds
or more to switch the display from
Fahrenheit to Centigrade or vice versa.
l
Press the OUTSIDE switch again to switch
the display from ambient temperature to the
temperature set for the air conditioner.
Interior Comfort
Interior Equipment
6-141
CX-9_8Z66-EA-08F_Edition1 Page381
Thursday, May 29 2008 10:9 AM
Form No.8Z66-EA-08F